Cape Island Style: Samson 32
Overall Length_
32'
Beam:Midship_
13'
Beam:Stern_
12'
Draft_
3' 5"
Description of hull and super structure standards:
  • Solid fiberglass hull
  • UV resistant, high gloss ISO gel coat
  • Coloured waterline
  • Hydrodynamic, tapered stern post
  • Wheelhouse built with fir plywood to customer spec
  • All plywood glassed inside and out with gel coat finish
  • 4 x 4 wheelhouse beams stained and varnished
  • PVC grab rails
  • Stainless steel bow cleat, stern and bow staples
  • 4- 4" bronze scuppers in recessed pockets
  • All sliding and folding doors on Teflon tracks
  • Drain plug in keel
  • Heavy duty PVC rub rail
  • 11 PVC windows
  • Lettering on boat
Deck Hatches
  • Deck hatches are aluminum set in Stainless Steel frames, common size 24 x 24 with any size available
Shafting

Straight shaft assembly complete with:

  • 9' X 316 Stainless Steel shaft comes with brass nut
  • Stainless Steel shaft log with cutless bearing &inside box
  • 4 bolt heavy duty steady bearing
  • Shaft coupling
  • Anodes
  • Installation
  • Propellor 24”-26”
Steering

Single station hydraulic steering complete with:

  • 1250 Capilano helm pump - 3.4 cubic inch displacement
  • BA 150 - 7 TMB cylinder with ball joint end
  • Hydraulic hoses, fittings
  • 1 ½" Stainless Steel rudder stock and 1/4" rudder plate
  • Installation
Fuel Tanks
  • 2 Stainless Steel fuel tanks constructed with 11 gauge 2B finish plate
  • 1 ½” fill lines and 1 ½" Stainless Steel deck fills
  • 3/4" vent lines
  • ½" suction hose (hydraulic hose) from one tank
  • shut off valve
  • inter connecting line (3/4" hydraulic hose )
  • ½" return line to one tank
  • installation
  • 100 gallon
Electrical
  • 11 circuit load center
  • Group 8D cranking battery
  • Battery box #4 electrical mains, #2/0 starter cables
  • 4 running lights port starboard, stern, masthead, + anchor light set
  • Stainless Steel dome lights
  • Pantograph windshield wipers - heavy duty
  • Rule 2000 GPH bilge pump 3-way switch float hose
Engine Installation
  • Installation, alignment and bolting
  • Solid fibreglass engine beds
  • 2 x 1 ¼ thru hulls seacock, bronze fittings hoses heavy duty clamps strainer
  • Kobelt controls and cables twin
  • 4 wet exhaust through stern / no muffler
Accommodations
  • Table with benches
  • Bottom bunks
  • Cupboard and counter top
  • Electric Marine head with brass fittings, thru hulls including enclosure with Y-valve and holding tank
  • Moulded helmsman seat
  • Swim platform
  • Fiberglass pull pit
  • Oak trim with cupboard doors
  • Bow Rail

Other options are available upon request. Please contact us for pricing.

 

 

 

 

Home | About | Contact | Commercial | Pleasure | Hull Kits | TraveLift | Storage | Map | Gallery