| Description of hull and super structure standards: |
- Solid fiberglass hull
- UV resistant, high gloss ISO gelcoat
- Coloured waterline
- Hydrodynamic, tapered stern post
- 5’ Wheelhouse built with fir plywood to customer spec.
- All plywood glassed inside and out with gel coat finish
- 4 x 4 wheelhouse beams stained and varnished
- PVC grab rails
- Stainless steel bow cleat, stern and bow staples
- 6- 4" stainless steel scuppers in recessed pockets
- All sliding and folding doors on Teflon tracks
- Drain plug in keel
- Heavy duty PVC rub rail
- 9 fixed PVC windows
|
| Deck Hatches |
- Deck hatches are aluminum set in Stainless Steel frames, common size 24” x 24”, any size available.
- Bomar Hatch in Cuddy 24 x 24
|
| Shafting |
Straight shaft assembly complete with:
- 13' X 316 SS shaft comes with brass nut
- Stainless Steel shaft log with cutlass bearings and inside box
- 4 bolt heavy duty steady bearing
- Shaft coupling
- Anodes
- Installation
- Propeller blade 28” – 30” Diameter
|
| Steering |
Single station hydraulic steering complete with:
- Hydraulic pump comes with pulley, belt and mounting bracket
- Steering unit comes with 15" Stainless Steel steering wheel, Stainless Steel spindle and mounting plate
- Dual ram steering unit with nitrated steel piston shafts
- Hydraulic hoses, fittings
- 2" Stainless Steel rudder stock and 28" X 26"X 1/4" SS rudder with support wings
- Installation
|
| Fuel Tanks |
2 Stainless Steel fuel tanks constructed with 11-gauge 2B-finish plate:
- 2" fill lines and 2" Stainless Steel deck fills
- 1" vent lines
- 3/4" suction hose (hydraulic hose) from one tank
- shut off valve
- inter connecting line (3/4" hydraulic hose )
- 3/8" return line to one tank
- installation
- 2 tank whistlers
- 200 gal
|
| Electrical |
- 11 circuit load center
- Group 8D cranking battery
- Battery box #4 electrical mains, #2/0 starter cables
- 4 running lights port starboard, stern, masthead, + anchor light set
- Stainless Steel dome lights
- Pantograph windshield wipers - heavy duty
- Rule 2000 GPH bilge pump 3-way switch float hose
|
| Wash Down / Bailing Pump |
- Jabsco 1 ½" 3-way ball valve
- bronze fittings
- 1 ½" thru hull and sea cock
- reinforced PVC hoses
- Wash down hose nozzle
- Installation
|
| Engine Installation |
- Installation, alignment and bolting
- Solid fibreglass engine beds
- 2 X 1 ½” thru hulls, seacocks, bronze fittings, hoses, heavy duty clamp, strainer
- Kobelt controls and cables twin
- 6” wet exhaust thru stern / no muffler
|
| Accommodations |
- Table with benches
- Top and bottom bunks
- Cupboard and counter top
- Manual marine toilet with brass fittings, thru hull, including enclosure
- 3-outlet engine heated heater
|
| Options |
- Stainless Steel Bow rail
- Galvanized Steel Prop cage
- Cross tree / radar arch FRP
- Engine
- Hydraulics 12” lobster package with Direct Drive and Aluminum Mast
- Electronics
- Sliding windows PVC
- Builders Risk
- Lettering
|
