| Description of hull and super structure standards: |
- Solid fiberglass hull, UV resistant, high gloss ISO gelcoat
- Built in speed rails, spray rails
- Hydrodynamic, tapered stern post
- Molded fiberglass shoe ( integrated with hull )
- Two piece molded superstructure from foredeck to back of wheelhouse with molded-in non-skid finish
- Molded fibreglass helm station
- Fiberglass roof with visor, laminated to wheelhouse
- PVC grab rails on wheelhouse and cuddy roof
- Stainless steel bow cleat, stern and bow staples
- Cored deck, wheelhouse main bulkhead and roof
- 2 Scuppers
- Sliding door on Teflon tracks
- Drain plug in keel
- Heavy duty PVC gunwale
- Lettering and decals
- 10 PVC framed windows
|
| Deck Hatches |
- Deck hatches are aluminum set in Stainless Steel frames, common size 24 x 16 with any size available
|
| Shafting |
Straight shaft assembly complete with:
- 9' X 316 SS shaft comes with brass nut
- Outside packing box
- 4 bolt heavy duty steady bearing
- Shaft coupling
- Anodes
- Installation
|
| Steering |
Single station hydraulic steering complete with:
- 1250 Capilano helm pump - 3.4 cubic inch displacement
- BA 150 - 7 TMB cylinder with ball joint end
- Hydraulic hoses, fittings
- 1 ½" S steel rudder stock and 1/4" rudder plate
- Installation
|
| Fuel Tanks |
2 Stainless Steel fuel tanks constructed with 11 gauge 2B finish plate
- 1 ½"fill lines and 1 ½" SS deck fills
- 3/4" vent lines
- ½" suction hose (hydraulic hose) from one tank
- shut off valve
- inter connecting line (3/4" hydraulic hose )
- ½" return line to one tank
- installation
- 150 gallon
|
| Electrical |
- 11 circuit load center
- Group 8D cranking battery
- Battery box #4 electrical mains, #2/0 starter cables
- 4 running lights port starboard, stern, masthead, + anchor light set
- Stainless Steel dome lights
- Pantograph windshield wipers - heavy duty
- Rule 2000 GPH bilge pump 3-way switch float hose
|
| Engine Installation |
- Installation, alignment and bolting
- Solid fibreglass engine beds
- 2 x 1 ¼ thru hulls seacock, bronze fittings hoses heavy duty clamps strainer
- Kobelt controls and cables twin
- 4 wet exhaust through stern / no muffler
|
| Accommodations |
- Table with benches
- Bottom bunks
- Cupboard and counter top
- Electric Marine head with brass fittings, thru hulls including enclosure with Y-valve and holding tank
- Moulded helmsman seat
- Swim platform
- Fiberglass pull pit
- Oak trim with cupboard doors
- Bow Rail
|
